BaumaLight S4 Stump Grinder - for skidsteer or small excavator. with S450 Motor suitable for 45-80 LPM flow
The S14 stump grinder (S450) is designed with simple operation in mind, with no required electrical connection. The direct flow hydraulic drive is designed to provide the best torque and RPM to the cutting head as no flow is diverted to a swing cylinder. The S14 mini tool carrier stump grinder features green carbide teeth which can be rotated three times, letting you grind stumps longer and faster on very low flow. The unique positioning of the rotor allows the operator an excellent view of the grinding action and the heavy duty fixed deflector safely directs the flow of debris. Cutting depth is up to 10" below ground. The S14’s size and the available mini excavator mount makes it a great stump grinder for better access to tight areas .By a quick pull of two pins a standard plates can be changed from Mini skidsteer , Skidsteer or excavator mounting. ( Mounting plates not included , but can be ordered seperately )
FEATURES AND BENEFITS
Made in Canada
-Wearsharp teeth The unique design of the Wearsharp® allows the tooth to retain a sharp cutting surface, unlike traditional teeth that tend to round over. This provides a consistent cut throughout the life of the tooth, allowing you to maintain a faster sweep speed. This round tooth is 3 teeth in 1. Simply loosen the lock nut and rotate the tooth to a fresh, sharp cutting edge. This can be done three times, extending the life of each tooth.
-6 Free teeth. All S14 Stump Grinder comes with a free set of 6 replacement teeth. These replacement teeth are conveniently shipped in the owner’s manual tub bolted to the frame.
-More Teeth. The high number of teeth means that each tooth needs to do less work. Each of the Stump Blasters teeth only need to make a small cut, because the work is shared by more of our rugged teeth they last longer and usually only require 2 or 3 replacements at a time. The bolt-on designed teeth allow for straightforward replacement.
-More Clearance. The Stump Blaster’s carbide teeth extend a full 1-¼ inches from the rotor. This prevents chips and mulch from getting plugged. More chip clearing produces smoother operation and reduces heat build-up that can damage the rotor and cause premature tooth failure.
-Rotor. The massive ¾" thick steel rotor provides the back bone for the Stump Blaster cutting system. It’s the anchor for the carbide tipped teeth. For smooth operation it’s important that the rotor remains solid, with no flexing. The rugged rotor also provides the Stump Blaster with the extra momentum needed when the grinding is tough, making sure the Stump Blaster can power through the hardest stumps.
-Greasable pins.Our grease pins are zinc plated to prevent corrosion which will allow for smoother operation of the units joints over their lifetime.
|Recommended Hydraulic Flow S450 Motor
|12-22 GPM or 45-80 LPM
|Recomended carrier size
|S450 Gerotor Roller Vane Motor
|RPM at max flow
|Green carbide teeth(H3000)
|Cutting Wheel speed
|Depends on Gpm
|6" below ground 152mm
|Max cutting depth per pass
|Max Horizontal cut
|12 " 305mm